Save time & money, The problem solver – GE ZET2S User Manual

Page 39

Advertising
background image

39

Save time
& money!

PROBLEM

POSSIBLE CAUSE

CLOCK AND TIMER

• A fuse in your home may be blown or the circuit breaker tripped.

DO NOT WORK

Replace the fuse or reset the circuit breaker.

• Oven controls improperly set. See the Clock and Timer sections.

OVEN

• Oven thermostat needs adjustment. See the Oven thermostat

TEMPERATURE

adjustment section.

TOO HOT OR
TOO COLD

OVEN DOOR WILL

• The oven is too hot. Allow the oven to cool below locking temperature.

NOT OPEN AFTER
A CLEAN CYCLE

LOCKED

• The self-clean cycle has been selected but the door is not closed.

FLASHES IN

Close the oven door.

THE DISPLAY

LOCKED LIGHT

• The oven door is locked because the temperature inside the oven has

IS ON WHEN YOU

not dropped below the locking temperature. Turn the Oven Mode

WANT TO COOK

and the Temperature knobs to OFF. Allow the oven to cool.

F9 FLASHES

• The oven has a function error code. Turn the Oven Mode and the

IN THE DISPLAY

Temperature knobs to OFF. Allow the oven to cool for one hour. Put the
oven back into operation.

• Disconnect all power to the oven for 30 seconds and then reconnect

power. If the function error code repeats, call for service.

DISPLAY GOES

• A fuse in your home may be blown or the circuit breaker tripped.

BLANK

Replace the fuse or reset the circuit breaker.

• The clock is in the black-out mode. See the Special Features section.

DISPLAY FLASHES

• Power failure. Reset the clock.

UNABLE TO GET

• The PROBE and the DELAY START buttons must be pushed at the

THE DISPLAY TO

same time and held for 4 seconds.

SHOW SF

“PROBE” APPEARS

• This is reminding you to enter a probe temperature after plugging in

IN THE DISPLAY

the probe. Enter a probe temperature.

POWER OUTAGE,

• Power outage or surge. Reset the clock. If the oven was in use, you

CLOCK FLASHES

must reset it by pushing the CLOCK button, turning and pushing the
Mini-Knob to enter.

STEAM FROM

• When using the convection feature, it is normal to see steam coming

THE VENT

out of the oven vent. As the number of racks or amount of food being
cooked increases, the amount of visible steam will increase.

“BURNING” OR

• This is normal in a new oven and will disappear in time.

“OILY” ODOR
EMITTING FROM
THE VENT

STRONG ODOR

• This is temporary. An odor from the insulation around the inside of the

oven is normal for the first few times the oven is used.

FAN NOISE

• A cooling fan or a convection fan (depending on the function you are

using) may turn on. This is normal. The cooling fan will turn on to cool
internal parts. It may run after the oven is turned off. The convection fan
may cycle on and off until the function is over or the door is opened.

The Problem Solver

Wall Oven

Advertising
This manual is related to the following products: