GE GP94DNSRSA - Manual (Page 4)

Operating Instructions
Safety Instructions
Consumer S
uppor
t
Tr
oubleshooting Tips
4
O N/ O FF
H OT W ATER T EMP
P RIORITY
I N U SE
A PPROX W ATER T EMP
°F / °C
Operating instructions.
This water heater is one of the most advanced water heaters
available. It provides a continuous supply of hot water at a
preset temperature. This appliance is direct vent, where air
is brought in from the outside and combustion gases are
exhausted to the outside.
While electricity, water and gas supplies are connected,
this water heater produces hot water whenever a hot water
tap is open.
Ignition is electronic. There is no pilot light consuming gas
while the water heater is not being used. The gas burner lights
automatically when the hot water tap is opened and goes out
when the tap is closed.
The temperature of the outgoing hot water is constantly
monitored. The water heater may adjust the water flow in
order to maintain the temperature setting. The water flow
may vary from summer to winter due to the difference in
ground water temperature.
NOTE: We do not recommend installing a remote control
outdoors.
For outdoor unit only, installation of the indoor remote
control is highly recommended. The remote control can set
the temperature within a specific range and can provide
error codes to diagnose any problems.
NOTE: Indoor models have an integrated control
with optional remote controls. Outdoor models have
a remote control intended to be mounted indoors.
In-Use Indicator
Indicates that hot water is being supplied
(i.e. a hot water tap is open).
Temperature Display
Shows the temperature setting. When a fault
is detected, a two-digit error code flashes on
this display.
Thermostat Adjustment
Increases or decreases the temperature
setting.
Priority Indicator
When lit, indicates that the control is setting
the temperature. (Always ON when only one
control is connected.)
Priority Button
When using an optional remote control(s),
the priority can be switched to another
control by pressing its Priority Button when
no hot water is running. This feature is
available with multiple remote controls.
ON/OFF Button
Used to turn the water heater ON or OFF.
Control Features