Graco RESPOND 2M06 - Manual (Page 5)

Operation
To Listen To Baby
• Turn on Nursery Unit using the ON/OFF switch.
• Turn on Parent Unit using the ON/OFF switch.
• Adjust the volume on the Nursery Unit and Parent Unit by turning the Volume Up/Down knob.
• The Sound Lights on the Parent Unit will illuminate as your child (or other objects) make noise near the Nursery Unit.
Please note that the Sound Lights and volume control on the Parent Unit are independent of each other. When the volume
is turned all the way down, the Sound Lights will still illuminate as your child (or other objects) make noise near the Nursery
Unit.
5
Clock and Timer
To Set Clock:
• When the battery is first plugged in, the clock will beep and a few seconds later blink “12:00”.
• To set the hours, push the S1 button to the desired time. A small “PM” will appear on the left side of the window to
designate “pm”.
• To set the minutes, push the S2 button to the desired time.
• Once the correct time is displayed in the window, push the S3 button to start the clock.
To Change the time:
• To change the time push the S3 button and hold it down for 5 seconds. Repeat the steps above to change the time. Push
S3 to start the clock.
Timer Feature:
To Count UP from 0 (up to 19 hours and 59 minutes):
• Press both S1 and S2 buttons at the same time. The display will be “0:00”.
• Press the S3 button. The word “UP” will appear on the upper right side of the window and the timer will start to count up.
• To stop the timer push S3 again. You may stop and start the timer by pressing the S3 button.
• To reset the timer to “0:00”, press both the S1 and S2 buttons at the same time.
• If you want to view the clock time while in count up mode, press and hold the S1 button. Releasing the button will display
the counter again.
• To return to the clock, Push S1, S2 and S3 at the same time.
To set the alarm for a specific amount of time (up to 19 hours and 59 minutes):
• Press both S1 and S2 at the same time. The display will be “0:00”.
• Press the S1 button to set the hours up to 19 hours.
• Press the S2 button to set the minutes up to 59 minutes.
• Press the S3 button. The word “DOWN” will appear in the lower right corner of the window and the colon will blink.
• When the alarm sounds press the S3 button to stop the beep.
• To reset the alarm to “0:00” press the S1 and S2 buttons at the same time.
• If you want to view the clock time while in count down mode, press and hold the S1 button. Releasing the button will
display the counter again.
• To return to the clock, Push S1, S2 and S3 at the same time.