Gateway 7450R - Manual (Page 82)

74 Gateway 7450R Server System Manual
To install the SNMP agent in Windows NT:
1 Add the IP address or hostname of the server to the SNMP setup. This
SNMP service routes SNMP service alerts to ManageX.
2 Install ManageX from the Server Companion CD (SCCD).
3 Run SETUP.EXE from the SCCD. The default directory is \Program
Files\7450R Agent.
4 Restart the server.
5 Setup ManageX. See “Setting up ManageX” on page 75.
Installing the SNMP agent in Windows 2000
The server must be prepared for the server management software.
■ SNMP service must be installed. If not, install SNMP service through
Windows 2000 before you install the SNMP agent.
To install the SNMP agent in Windows 2000:
1 Add the IP address or hostname of the server to the SNMP setup. This
SNMP service routes SNMP service alerts to ManageX.
2 Install ManageX from the Server Companion CD (SCCD).
3 Copy WBEMSNMP.EX_ from the \i386 directory on the SCCD to a local
drive.
4 Open a DOS command prompt window and type expand
D:\WBEMSNMP.EX_ C:\WBEMSNMP.EXE, where D is the drive and
directory where you copied WBEMSNMP.EX_ and C is the drive and
directory where you want to place the expanded file, then presss E
NTER .
5 Type WBEMSNMP at the command prompt, then press E NTER .
The system will display the welcome screen with the title Welcome to the
WMI SNMP Provider Installation Wizard. When the welcome screen is
displayed, continue with the installation.
6 Click Start , then select Settings , then Control Panel .
7 Double-click Add/Remove Hardware .
8 Click Add/Troubleshoot a device , Add a new device , then No, I want to select
the hardware from a list .
8507328.book Page 74 Thursday, February 15, 2001 11:28 AM