Grizzly H3119 - Manual (Page 6)

H3119 Electric 3 ⁄ 16 " Crown Stapler -4 -
OPERATION
Getting Started
Please take the time to become familiar
with this instruction manual. The informa-
tion contained will allow you to get the
maximum enjoyment and use from your
new tool.
Loading The Stapler
The Model H3119 can hold up to 85 sta-
ples in the quick loading magazine.
To load the stapler:
1. Unplug the tool from the power
source!
2. Press the silver lever while sliding back
on the staple magazine.
3. Point the tip of the stapler upward to
reveal the stapler loading area.
The
loading area consists of a groove or
channel that runs along the bottom of
the stapler.
4. Load a stick of 20 gauge 3 ⁄ 16 " crown
staples 1 ⁄ 4 " to 9 ⁄ 16 " long into the loading
area.
5. Slowly slide the staple magazine back
into the closed position until the silver
lever latches in the closed position.
Using The Stapler
1. Be sure the stapler is loaded and the
magazine is closed securely.
2. Wear safety glasses when using the
stapler
3. Plug the stapler into a 110V power
source.
4. Place the tip of the stapler against the
workpiece and pull the trigger.
DO NOT pull the trigger until the tip
of the stapler is against the surface
to be stapled. The stapler does NOT
have a safety mechanism.
Avoid repeatedly shooting staples
into the exact same location without
moving the tip of the stapler. A staple
could become jammed in the tip of
the stapler.