English – GIGABYTE AMD Socket 939 Processor Motherboard GA-K8N51PVM9-RH User Manual
Page 68
GA-K8N51PVM9-RH-NV Motherboard
- 68 -
English
Figure 1
In the SATAII RAID Config submenu, enable SATA-II RAID function. Then enable the SATA ports
with hard disks that you want to use for RAID. In the example in Figure 2, enable SATA-II 1 Primary/
Secondary RAID or SATA-II 2 Primary/Secondary RAID). (For example, if you wish to create RAID
with hard disks on the SATAII0 and SATAII1 connectors, set SATA-II 1 Primary/Secondary RAID to
Enabled).
CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
SATAII RAID Config
Item Help
Menu Level
SATA-II RAID function
[Disabled]
x SATA-II 1 Primary RAID
Disabled
x SATA-II 1 Secondary RAID
Disabled
x SATA-II 2 Primary RAID
Disabled
x SATA-II 2 Secondary RAID
Disabled
: Move
Enter: Select
+/-/PU/PD: Value
F10: Save
ESC: Exit
F1: General Help
F5: Previous Values
F6: Fail-Safe Defaults
F7: Optimized Defaults
(2) Configuring SATA controller mode and boot sequence in BIOS Setup
You have to make sure whether the SATA controller is configured correctly in system BIOS Setup and
set BIOS boot sequence for the SATA hard drive(s)/RAID array.
Step 1:
Turn on your computer and press Del to enter BIOS Setup during POST (Power-On Self Test). In the
example in Figure 1, make sure that Serial-ATAII 1 or Serial-ATAII 2 under the Integrated Periph-
erals menu is enabled (Serial-ATAII1 controls the SATAII0/1 connectors and Serial-ATAII2 controls the
SATAII2/3 connectors). If you wish to create RAID array, press ENTER on the SATAII RAID Config
item to enter the submenu .
Figure 2
The BIOS Setup menus described in this section may not show the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
CMOS Setup Utility-Copyright (C) 1984-2006 Award Software
Integrated Peripherals
SATAII RAID Config
[Press Enter]
On-Chip IDE Channel0
[Enabled]
On-Chip IDE Channel1
[Enabled]
IDE1 Conductor Cable
[Auto]
IDE2 Conductor Cable
[Auto]
Serial-ATAII 1
[Enabled]
Serial-ATAII 2
[Enabled]
On-Chip USB
[V1.1+V2.0]
USB Keyboard Support
[Disabled]
USB Mouse Support
[Disabled]
Onboard Audio Function
[Auto]
Onboard LAN Function
[Auto]
Onboard LAN Boot ROM
[Disabled]
Legacy USB storage detect
[Enabled]
Onboard Serial Port 1
[3F8/IRQ4]
Onboard Parallel Port
[378/IRQ7]
Parallel Port Mode
[SPP]
: Move
Enter: Select
+/-/PU/PD: Value
F10: Save
ESC: Exit
F1: General Help
F5: Previous Values
F6: Fail-Safe Defaults
F7: Optimized Defaults
Item Help
Menu Level