Garmin Edge 500 - Manual (Page 30)

 Edge 500 Owner’s Manual
ANT+ Sensors
Reset
button
Cable
ties
Indication
line
GSC 10 on rear
Chain Stay
2. Loosely attach the GSC 10 using
two cable ties.
3. Attach the pedal magnet to the
crank arm using the adhesive mount
and a cable tie.
The pedal magnet must be
within 5 mm of the GSC 10. The
indication line on the pedal magnet
must line up with the indication line
on the GSC 10.
Cable
tie
Pedal Magnet on
Crank Arm
Indication
line
4. Unscrew the spoke magnet from the
plastic piece.
5. Place the spoke in the groove of the
plastic piece and tighten slightly.
The spoke magnet can face away
from the GSC 10 if there is not
enough room between the sensor
arm and the spoke. The spoke
magnet must line up with the
indication line on the sensor arm.