Hardware design, Warning, I/o interface specifications – Global Technology Associates GB-2000X User Manual

Page 2: Led status indicators

Advertising
background image

Hardware Design

The GB-2000X chassis is a 1-RU unit designed to

minimize heat buildup with two cooling fans. It has six

high speed 10/100 Mbps Ethernet interfaces to ensure

high performance and network design flexibility, one

DB-9 serial interface to provide access for a serial

console, one DB-9 serial (COM) interface for a dial-

up modem/ISDN TA, and two USB interfaces. Flash

memory stores and runs the pre-installed GNAT Box

System Software. Power is supplied by a power cable.

A reboot may be triggered using the “Reset” pin hole.

Caution

At least

6” should be provided behind the system

to allow efficient cooling. Inadequate clearance

can cause the system to overheat.

Warning

There are no user serviceable or upgradeable parts

in the GB-2000X. Opening the unit will void the

warranty on the system, and may cause injury.

I/O Interface Specifications

Six (6) 10/100 Mbps Ethernet 10Base-T network

interfaces on UTP Cat. 3, 4 and 5, and fast Ethernet
100Base-TX network interfaces on UTP Cat. 5.
NIC 0 is factory set to IP address 192.168.71.254 .

• Two (2)

DB-9 (RS-232) serial interfaces

The serial console / modem port should be set to
38,400 bps, 8 bit, 1 stop, no parity and flow control
to hardware.

• Two (2) USB interfaces
• Two (2) PCI expansion slots

LED Status Indicators

Front Panel LEDs

Power LED

When the firewall is powered up, the
green Power LED on the front panel
will be lit.

Disk LED

The red LED will light when the
Compact Flash disk is accessed.

10/100 LED

The green LED will remain unlit if a 10
Mbps connection is established; it will
light if a 100 Mbps connection is estab-
lished. Each 10/100 LED is located on
the associated Ethernet connector.

Link/Activity

LED

The green LED will light and remain
solid when an Ethernet connection is
established; it will blink when activity
occurs over that connection. Each Link/
Activity LED is located on the associ-
ated Ethernet connector.

© 2005 Global Technology Associates, Inc. [email protected]

���

3

4

5

2

1

0

10/100 Ethernet

Interfaces

Power

LED

Serial

Console

Port

Power

Swich

Power

Socket

Exhaust Vents

Serial COM

Port

Expansions

USB Ports

Exhaust

Vent

Advertising