Genie GTH-1056 - Manual (Page 51)

OPERATION
PLACING A LOAD
4 - 13
SWAY CONTROL
PUM P OFF
BRAKE ON
( C) LE TT E R VI SI BL E = 3,000 LBS
( D) L ET TE R VISI BLE = 2,000 L BS
P /N 3-1483 0 ( 1.22)
METER FEET ( 6.10) 28 (8.54) 24 (7. 32) 20
4
!"#"$ &' ()*"#+ 455 NORTH S UPERI OR AVENUE
MACHINE ON A FIRM, LEVEL
SURFACE WITH UNDAMAGED,
PROPERLY I NFLATED CALCIUM
CAP ACI TY I S PER ANSI B56.6
LOAD LI MI TS / HORIZONTAL BOOM
( B) LETTER VI SIBLE = 4,000 LBS
OR OP TI ONAL FOAM FI LLED TIRES . CHLORI DE SOLUTION FI LLED TIRES
RATED LI FT CAP ACITIES ARE WITH :
LAST FULLY VI SIBLE LETTER (A) LETTER VIS IBLE = 6,000 LBS RETRACTED = 8,000 LBS
REAR AXLE LOCK-UP ENGAGED.
(.61 METERS ) LOAD CENTER WI TH
MANUFACTURER'S RECOMMENDED S TABI LITY TESTS US ING STANDARD ( 1.22x1.22 x1.22 METERS) . LOAD HOMOGENEOUS CUBES 4x4x4 FT.
P.O. BOX 790 PHONE 906-353- 6675
FAX 906- 353-7543
CAP ACITIES AT 24 I NCH STANDARD F ORK F RAME.
BARAGA, MICHI GAN 49908
12 ( 3.66) 16
( 14.64) 48 METER FEET ( 6.10) 28 (8.54) 24 (7. 32) 20
32
20 24 ( 7.32) ( 8.54) 28 ( 9.76)
44 ( 13.42) 40 36 ( 10.98) ( 12.20)
0
( 4.88)
(4.88) 12 (3.6 6) 8 16 (6.10) 20 4 ( 1.22) (2.44)
(4.88) 12 (3.6 6) 16 ( 6.10) 20
HEAT ER HEADLIGHT LEFT STABILIZ ER RI GHT STABI LIZ ER
B LIN
E NGINE
SWAY
CONTROL
WARNING
Do not sway the machine with the boom angle indicator arrow
(B) at more than 0 degrees. By doing so you could cause a roll
over hazard which may result in injury or death.
DANGER
Always apply the parking brake (C) before lifting and/or
placing a load. Failure to do so could allow the machine to roll
over which may result in injury or death.
CAUTION
Always bring the machine to a complete stop before applying
the parking brake (C). Failure to do so will damage the parking
brake disc packs, which may void the axle warranty.
Before placing a load, the frame should be leveled. This can be
done by the use of the switch labeled sway control (D) located
on the lower right hand side of the dash panel in front of the
operator.
Adjust the sway control (D) until the indicator ball on the level
gauge (E) is on the 0 degree mark.
B
C
E
D