Grundig TRAVELLER II PE - Manual (Page 7)

7
Setting the Time
Home Time
- Set the TIME SET switch (9) to HOME position.
- Press the triple function key (2) to select 12-hour AM/PM or 24 hour
display mode.
-Use >H< (13) and >M< (11) TIME ADJUSTOR for your home time on
the MAIN TIME display (3A).
Use the >M< key (11) to set the second TO >00< on the SUB TIME
display (3E).
-Put the TIME SET switch (9) to LOCK position.
World Time
- Set the TIME SET switch (9) to WORLD position.
- Turn the WORLD TIME SELECTING switch (8) towards the city with the same
time zone as that of your hometown.
- Use the >H< (13) and >M< (11) TIME ADJUSTOR to adjust the time in the SUB
TIME display (3E) with exactly the same Hour and Minute fixed on the MAIN
TIME display (3A).
- Put the TIME SET switch (9) back to LOCK position.
Select the World Time
Turn the WORLD TIME SELECTING switch (8) towards the name of any city
with the same time zone as the place you want to locate, shown on the time
scale and on the cover.
You can easily read it's present time shown on the display as WORLD time. At
the same time you can read your home time, shown on the display as HOME
time.
Notes:
The MAIN TIMER with large figures shown on part (3A) of the display is
normally fixed as HOME TIME, and the SUB-TIMER on lower part (3E) with
smaller figures normally shows WORLD TIME when the switch HOME-WORLD
is positted on HOME.
However, the 2 timings can be exchanged for both positions and figures when
this switch be set to WORLD position.
-When installing the clock battery or the unit be wrongly operated, maybe it
will cause the LCD to show abnormal figures or the colons of clock stop blinking
or even not display at all, use a toothpick or any equivalent to sting the RESET
HOLE (12) slightly so that the clock system will reset to its normal and initial
condition.
If not necessary do not try to sting the RESET hole.