Global Machinery Company DSSCR 710W - Manual (Page 10)

10
Cleaning
1. Keep your machine and its cord clean. The outside of
the machine can be cleaned using a damp soft cloth
with a mild detergent if required.
2. Some maintenance products and solvents may damage
the plastic parts; these include products containing
benzene, trichloroethylene, chloride and ammonia.
3. Excessive sparking generally indicates the presence
of dirt in the motor or abnormal wear on the carbon
brushes.
4. Take special care to keep the ventilation inlets/outlets
free from obstruction; cleaning with a soft brush
followed by a compressed air jet will usually be
sufficient to ensure acceptable internal cleanliness.
5. Wear eye protection when carrying out cleaning.
CAUTION. Do not use cleaning agents to clean the plastic
parts of the drill.
Power cord maintenance
If the supply cord needs replacing, the task must be
carried out by the manufacturer, the manufacturer’s
agent, or an authorised service centre in order to avoid
a safety hazard.