GE MODEL WA7800R - Manual (Page 9)

How to Use the Mini-Quick Cycle
The MINI-QUICK cycle is a 1. Follow steps through 8
short cycle, intended to wash on opposite page except for
small loads of lightly soiled cycle selection.
clothes you need in a hurry.
2. Push the Cycle Selector knob
The Mini-Basket tub should be in and turn it clockwise to the
used for satisfactory results. MINI-QUICK cycle.
3. Pull the Cycle Selector knob out
to start the washer.
I
I I
How to Use the Filter-Flo Pan
●
The Filter-Flo pan is the lint
filter. Position the Filter-Flo -
pan on the agitator after
loading clothes into the
washer. Lint is easily seen
and removed after the wash
is finished.
NOTE: Do not use the Filter-Flo pan as a wash
.... . .. .. . ..
basket. Do not put items to be washed in the
Filter-Flo pan. Do not place detergent packets
. . . . . . . . . .. . . . ..
+... ->--- in the Filter-Flo pan.
. . .,. ,
The Filter-Flo pan also serves as a lid for the
. .
. . . . . . . . . . .
Mini-Basket tub, See How to Use the Mini-Basket
Tub section.
How to Use the Bleach Dispenser
●
Use this dispenser with
liquid bleach only.
If you prefer to
use powdered
bleach, pour it
into the wash
basket along with
your detergent. Do
not pour powdered bleach
into-the bleach dispenser.
●
Measure bleach carefully.
Here are some recommended amounts:
LARGE WATER LEVEL—1 cup (310 ml) liquid
SMALL WATER LEVEL—2/3 cup (170 ml) liquid
MINI-BASKET tub—1/4 cup (60 ml) liquid
●
Pour measured amount of liquid bleach directly into
bleach dispenser.
●
Do not or allow dispenser to overflow.
Avoid splashing. Undiluted bleach can cause
fabric damage.
●
Never pour undiluted liquid bleach directly onto
clothes or into the wash basket or Mini-Basket tub.
How to Use the Soak Cycle
●
SOAK CYCLE
Regular
temperature will
automatically be
cold.
●
For a hot or warm
soak, set the
Temp.
Start the washer. After washer fills and begins to
agitate, push in the Cycle Selector knob and turn to
\
●
$
SOAK CYCLE. Pull out the Cycle Selector knob to
\\
❑
complete the cycle.
●
For an extended soak, allow the washer to fill and
agitate for a few minutes to dissolve the soaking
agent. Then push in the Cycle Selector knob to stop
control to HOT/COLD or WARM/COLD and the washer (keep lid closed) and allow to soak for as
turn the Cycle Selector knob to NORMAL in the long as desired. After desired soak period, pull out the
Regular Cycles. Cycle Selector knob to complete the cycle.
9