Grizzly G9742 - Manual (Page 19)

G9742 Metal Cutting Bandsaw (Mfg. Since 11/06
-17-
pulley Cover
figure 17..Positioning.the.pulley.cover.
figure 18..Belt.tension.knob.
To install the pulley cover:
1.. UNPLUG.THE.BANDSAW!
2.. Position. and. rotate. the. pulley. cover. into.
place.as.shown.in. figure 17.
3.. Install.the.two. 1 ⁄
4
-20.x. 1 ⁄
2
".hex.bolts.and.wash-
ers.that.secure.the.pulley.cover.
E N T A N G L E M E N T
HAzARD! you MUST
install the pulley cover
before operating!
Otherwise, severe injury
may occur.
Belt.Tension.
Knob
When.opened,.the.pulley.cover.gives.you.access.
to.change.the.pulley.ratio.so.the.bandsaw.can.cut.
at.one.of.three.speeds.
4.. Loosen. the. belt. tension. knob. enough. to.
install.the.belt.on.the.appropriate.pulley.that.
will. give. the. required. blade. speed.. Refer. to.
Blade Speed. on. page 19. for. blade. speed.
selections.
5.. Adjust.the.belt.tension.knob.(figure 18),.so.
the. belt. has. 1 ⁄
4
". deflection. when. pressed. in.
the.center,.and.close.the.cover.