GE JKP45 EN - Manual (Page 13)

Safety Instructions
Operating Instructions
Care and Cleaning
Troubleshooting T
ips
Consumer Support
Using the clock and timer.
www.GEAppliances.com
13
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
Press the CLOCK pad.
Press the HOUR and MIN + or
–
pads to set the time of day.
Press the START pad.
Make sure the clock is set to the
correct time of day.
To Set the Timer
Press the KITCHEN TIMER
ON/OFF
pad.
Press the HOUR and MIN + or
–
pads until the amount of time
you want shows in the display.
If you make a mistake, press
KITCHEN TIMER ON/OFF
and begin
again.
Press the START pad.
After pressing the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute
has passed.
When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the KITCHEN TIMER ON/OFF pad
is pressed.
The 6 second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the KITCHEN TIMER ON/OFF pad, then
press the HOUR and MIN + or – pads until
the time you want appears in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the KITCHEN TIMER ON/OFF pad
and then pressing the HOUR and MIN +
or – pads to enter the new time you want.
To Cancel the Timer
Press the KITCHEN TIMER ON/OFF
pad twice.