GE JRP28 - Manual (Page 21)

Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
21
ge.com
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface,
use warm sudsy water or a stainless steel
cleaner or polish. Always wipe the surface
in the direction of the grain. Follow the
cleaner instructions for cleaning the
stainless steel surface.
To inquire about purchasing stainless
steel appliance cleaner or polish, or to
find the location of a dealer nearest you,
please call our toll-free number:
National Parts Center
1.800.626.2002
ge.com
Stainless Steel Surfaces (on some models)
Control Knob
The control knobs may be removed for easier
cleaning.
Make sure the knobs are in the OFF
positions and pull them straight off the
stems for cleaning.
The knobs can be cleaned in a
dishwasher or they may also be washed
with soap and water. Make sure the inside
of the knobs are dry before replacing.
Replace the knobs in the OFF position to
ensure proper placement.
Control Panel
It’s a good idea to wipe the control
panel after each use. Clean with mild
soap and water or vinegar and water,
rinse with clean water and polish dry
with a soft cloth. Do not use abrasive cleansers, strong
liquid cleansers, plastic scouring pads or
oven cleansers on the control panel—they
will damage the finish. A 50/50 solution of
vinegar and hot water works well.
Spring clip
Clear groove
in stem
Molded rib
Glass Surfaces
To clean the outside glass finish,
use a glass cleaner. Rinse and polish
with a dry cloth. Do not allow the water or cleaner
to run down inside the oven door
while cleaning.
Painted Surfaces
Clean with soap and water or a vinegar
and water solution. Do not use commercial oven cleaners,
cleansing powders, steel wool or harsh
abrasives on any painted surface.