Gilson MORTAR-PLASTER 1200MP - Manual (Page 13)

12
DRUM SHAFT BEARING HANGERS
Drum yoke bearing hangers are located on each side of the drum, and are equipped with
grease fittings. These bearings should be lubricated once each week with lithium based
grade 2 multi-purpose grease.
ENGINE/MOTOR
Refer to the engine/motor operating instructions for all maintenance and lubrication
instructions and requirements.
JACK SHAFT BEARINGS
Pillow block style bearing are used on the drive train counter-shaft. See Drum Seal
Housing, Lubrication Guidelines for more information. See Figure 4 for bearing
locations.
8 – ADJUSTMENT
RUBBER WIPER BLADES
Adjust rubber wipers so they fit snugly against the drum but not to the point that they fold
over when the blades rotate.