Gateway 820 LTO - Manual (Page 22)

18
Chapter 3: Setting Up the Autoloader
www.gateway.com
Installing the autoloader into a
cabinet
The autoloader can be installed into an EIA 310-D standard 19-inch cabinet
(rack).
Requirements
To install the autoloader into a cabinet, you need:
■ #2 Phillips screwdriver
■ TORX T-10 screwdriver
■ The included cabinet mount kit — Make sure that the cabinet mount kit
contains the following items:
■ Two support rails
■ Two cabinet mount brackets
■ Ten screws
■ Ten clip nuts
Support rails
Cabinet mount brackets
Clip nut
Screw