GE DBLR453ET - Manual (Page 11)

Always follow Fabric Manufacturer Care Label or instructions when laundering.
Otherwise use the information below as a general guide.
Mend any holes or weak seams where feather or filling could
escape. Dry only one pillow at a time. Stop dryer occasionally and
shake pillow, redistributing filling for even drying. Check pillow
at the end of drying time. If it is not completely dry, reset dryer
for more drying time.
Dry on low heat only.
Do not dry pillows containing foam rubber.
Add 2–4 dry towels and one blanket and set timer for 20–25 minutes.
Dry only one blanket at a time. Do not set control for more than 25
minutes. At the end of drying cycle block the blanket back to
original shape. Allow blanket to dry thoroughly before storing.
Use a medium heat drying setting.
Use a low heat drying setting.
Use a low heat drying setting.
Use a low heat drying setting.
Dry only one extra large item at a time. Set dryer for 20 minutes.
comforters,
time is up, check and redistribute load. Reset dryer and
check after 15 minutes. time is up, check and redistribute
mattress
load. Reset timer and check at 5 minute intervals. Check after each
5 minutes to ensure articles do not fill dryer drum. Large, wet
articles should have ample room in the dryer, but as they dry
and fluff up they may not have room to tumble.
CAUTION: Items without room to tumble may block airflow and
could result in scorched items. Dry pads separately. Use
a low heat drying setting.