Clearances, Leveling, Location – GE Monogram Bottom Mount Built-In Refrigerators User Manual

Page 15: Clearances leveling location, Preparation, Refrigerator location

Advertising
background image

15

Preparation

Bottom Mount Refrigerator

Leveling

This model has 4-point leveling. All 4 corners
are supported by leveling legs. The front wheels
are non-adjustable; they are only used for
positioning the unit.

•

To level the back of the unit, turn hex nut
located above the front wheels.

•

To level the front of the unit, use a 1

1

/

4

″

open

end wrench and adjust the leveling legs.

•

Turn hex nut or front leveling leg clockwise
to raise the unit, counter-clockwise to lower
the unit.

See the Installation Instructions (Pub. No.
49-6983) for complete directions.

Refrigerator
location

Do not install refrigerator where temperature
will be below 60°F (16°C)

because it will not

run often enough to maintain proper
temperatures.

Do install it on a floor strong enough to support
a fully loaded refrigerator.

Clearances

If the refrigerator is to be installed in a corner,
allow 2

″

(51 mm) between the hinges of the

refrigerator and the wall to assure a 90° door
opening capability.

No other clearances at top, sides or back are
required.

Hex Nut

Wheel

Leveling Leg

Advertising