Global Machinery Company 2000W - Manual (Page 8)

8
Preparation of the blower vac prior to use
The BLV2000A blower vac requires some assembly prior
to use for the first time. This includes extending of the
teloscopic blower vac tube, fitting of the collection bag and
fitting of the shoulder strap to the housing.
Extending the telescopic blower vac tube
WARNING. The Blower Vacuum must be fully assembled
with the blower tubes fully extended and secured in place
before use.
1. Firmly take hold of the blow/vac tube - lower (12b) and
extend it out fully until the arrow on the lower tube is
clearly visible.
2. Two screws are supplied for
securing the tube in place.
With the blow/vac tube
- lower (12b) completely
lowered and the arrow
visible. Insert the two fixing
screws into the holes in the
blow/vac tube - upper (12a)
and through into the blow/vac
tube - lower (12b). Secure
tight with a screwdriver
(not supplied).
3. Lightly tap the plastic caps
on top of the fixing screws to
prevent from tamper.
To fit the collection bag
WARNING. Never operate the vacuum without the
collection bag attached.
Note. Always make sure the bag zipper is closed
when the unit is in use.
For use as a vacuum, the collection bag (5) must be fitted.
To fit the collection bag, turn the blower vac upside down
so the vacuum outlet is exposed.
1. Place the bag connector over
the vacuum outlet and push
the two collection bag locking
clips (9) inwards to secure the
collection bag firmly
in place.
2. Fit the top collection bag strap
onto the bag retaining clip
- upper (13a) and the lower
collection bag strap onto the
bag retaining clip - lower (13b).
To remove the collection bag
1. Unhook the collection bag straps from the upper and
lower bag retaining clips (13a & 13b).
2. Push the two collection bag locking clips (9) inwards and
pull the collection bag out and away from the housing (9)
of the blower vacuum.
EXTENSION MARK