Gateway MicroGate MG1-1000 - Manual (Page 13)

Basic Network Configuration Procedure
1. Start the Discovery Utility by selecting Start > Programs > Raptor Web
Software > ECSDiscovery – This utility might reside in a different location
depending on how it was installed.
Figure 4
2. Click on Start Discovery (see Figure 4, note #1) to start looking for E-Control
Systems’ units on your network. Note: This could take up to 30 seconds to
complete
Figure 5
3. A list of all of the ECS units on the network is listed sorted by their MAC
Address (see Figure 5, note #4). Find the MAC address of the MicroGate™
that you want to configure (the MAC address is shown on a white label on the
underside of the MicroGate™). Highlight the row in the table that corresponds
to the correct MAC Address/Unit you want to re-configure.
MicroGate™ User Manual 13