GBC QUANTUM P70IX - Manual (Page 16)

5. Home Screen
5-2
HOME SCREEN continued
Other commands from the HOME SCREEN are:
MODE: allows you to select between Automatic or Manual. Automatic Mode
means the Quantum will continue to run non-stop as long as you place paper on
the Input Belts and remove the punched stack of paper from the Output Belts.
The Manual Mode means the Quantum will stop before it takes the next paper
stack in for processing. This mode is helpful if you want to start a new job that
requires different settings such as a different Die Set for example.
PROOF: you can run a few lifts of your job and have the Quantum stop. This
feature enables you to check the hole positioning and pattern to ensure the
setup is the job you intended.
UNLOAD: means that when pressed, the job currently inside of the Quantum
will exit. This is helpful if you need to start a job over again for some reason.
JOB MANAGER: will take you to the Job Manager screen where a different job
can be selected or created.
LANGUAGE: you may select between English, Spanish, French and German.
1 2 3
4 5 6
7 8 9
0 OK
LANGUAGE PROOF
JOB MANAGER
90 LPM
PB .141
11"
8.5"
GBC QUANTUM PUNCH
UNLOAD
7
MODE