Gold's Gym GB 1500 GGBE19640 - Manual (Page 8)

8
8. Slide the Adjustment Bracket (9) through the
Bench Frame (1) as shown.
Lubricate an M10 x 168mm Button Bolt (52) with
the included grease. Attach the Backrest Frames
(10) to the Bench Frame (1) with the Bolt, two
M10 Washers (19), and an M10 Nylon Locknut
(62).
Do not overtighten the Locknut; the
Backrest Frames must be able to pivot easily.
Insert a Short Pin (32) through the Bench Frame
(1) and the Adjustment Bracket (9). Attach the
Short Pin to the Bench Frame with an M4 x
10mm Screw (42).
Tighten the four M8 Nylon Locknuts (58) used
in step 6 and the four M6 x 38mm Screws (51)
used in step 7.
9. Attach the Seat (12) to the Bench Frame (1) with
two M6 x 16mm Screws (46), an M6 x 63mm
Screw (28), and an M6 Washer (33).
10. Attach the Leg Lever Bumper (31) to the Leg
Lever (5) with an M4 x 16mm Screw (40). Make
sure the Bumper is attached as shown in the
inset drawing.
Attach the Weight Tube (16) to the Leg Lever (5)
with an M8 x 64mm Button Bolt (55), two M8
Curved Washers (54), a 14mm Spacer (41), and
an M8 Nylon Locknut (58).
11. Grease an M10 x 82mm Button Bolt (56). Attach
the Leg Lever (5) to the Front Leg (4) with the
Bolt and an M10 Nylon Locknut (62).
Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
Insert a Short Pin (32) into the Leg Lever (5).
Attach the Short Pin to the Leg Lever with an M4
x 10mm Screw (42).
10
1
62
19
19
Grease
52
42 32
8
9
10
11
9
12
1
33
28
46
46
5
55
54
41
16
54
31
31
Longer
edge on
bottom
40
58
56
Grease
62
42
32
4
5