Gefen EXT-DP-441 - Manual (Page 13)

IR REMOTE CONTROL UNIT
10
Corresponding DIP Switch Settings for each IR Channel
It is important that the IR channel on the Remote Control unit, matches the IR
channel set on the 4x1 DisplayPort Switcher. For example, if both DIP switches
on the IR Remote Control unit are set to IR channel 0 (both DIP switches down),
then the 4x1 DisplayPort Switcher must also be set to IR channel 0. See page
21 on how to change the IR channel on the 4x1 DisplayPort Switcher.
IR Channel 0
(default)
1 2
ON
How to Resolve IR Code Confl icts
In the event that IR commands from other remote controls interfere with the
supplied IR Remote Control unit, changing the IR Remote Control’s IR channel
will fi x the problem. The IR Remote Control unit has a bank of DIP switches used
for setting the IR channel. The DIP switch bank is located underneath the battery
cover.
Left: Picture of the
opened rear battery
compartment of the IR
remote showing the
exposed DIP Switch
bank between the
battery chambers.
IR Channel 2
1 2
ON
IR Channel 3
1 2
ON
IR Channel 1
1 2
ON
1 2