Grizzly G9749 - Manual (Page 28)

-26-
G9749 Variable Speed Drill Press
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
Protect the unpainted cast iron surfaces on the
table by removing vises and fixtures daily and by
wiping the table clean after every use.
Keep tables rust-free with regular applications of
products like G96
® Gun Treatment or Boeshield ®
T-9. See below for Grizzly model numbers:
G2871—Boeshield ® T-9 12 oz Spray
G2870—Boeshield ® T-9 4 oz Spray
H3788—G96 ® Gun Treatment 12 oz Spray
H3789—G96 ® Gun Treatment 4.5 oz Spray
Unpainted Cast Iron
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check:
•
Drill press is completely powered down at the
end of use.
• Excess cutting fluids and chips have been
removed and unpainted surfaces are dry and
protected.
• Floor mounting bolts are secure.
• Drill press is clean and lubricated.
• Examine wiring for damage or wear.
• Check for any other unsafe condition.
Schedule
The quill and table use a rack and pinion assem-
bly for movement. To ensure a smooth operation
and a long life of these rack and pinion systems,
lubricate as needed depending upon use.
Brush a small amount of multi-purpose grease on
the rack near the pinion (see
Figure 28 & 29).
Move the table or quill up and down to distribute
the grease.
Lubrication
Figure 28. Table rack lubrication point.
Note: All other bearings are lubricated and sealed
at the factory, and do not need further lubrica-
tion.
Figure 29. Quill rack lubrication point.