Gianni Industries Easiprox - Manual (Page 3)

Copyright © Gianni Industries, Inc. All Rights Reserved.
P-MU-EASIPROX Ver. F Published on 2011.02.14 Page: 3/ 4
4. Clear all memory
1. Read Master Card 3 times, each time within 2 seconds of interval (Yellow & Red LED stay on for
3 seconds and flash), enter clearing memory mode
2. Read any EM-400x 64-bit R/O compatible card except Master Card (Green LED flash → in the
process of clearing all memory, including Master Card)
3. Empty memory and back to default value (Yellow & Green LED flash)
4. Follow step 1 to set new Master Card
If the Master Card is lost, follow the steps below to clear all memory:
1. Turn off the power
2. Connect the two black cables and turn on the power
3. In the process of clearing all memory, including Master Card (Green LED flash)
4. Disconnect the two black cables (Yellow & Green LED flash → memory is empty)
5. Set relock time
1. Read Master Card 4 times, each time within 2 seconds of interval (Yellow LED stay on for 3
seconds, then flash), enter relock time setting mode
2. Each flash indicates 0.7 seconds. If the relock time is set to 5 seconds, after 7 flashes, read the
Master Card once. (Yellow LED stay on), back to standby mode
Note: The longest relock time is 42 seconds (60 flashes). After 60 flashes, the Yellow LED will
automatically stay on and go back to standby mode.
VI. TS-980 Tag Simulator (optional)
TS-980 Tag Simulator simulates any card/tag number stored in the memory of the reader. When you
plan to delete a lost card/tag from the memory, Tag Simulator is used to transmit the number of the lost
card/tag to the reader and then you can begin to delete it from the memory.
For example: delete the card, ABA code 0001206932. Press On/Off continuously. When the screen
displays , press → , and press → .
Repeat the preceding step. When the screen displays , and the reader enters deleting
card mode, press Send (The distance between the Tag Simulator and the reader must be within 3 cm.)
Card deletion is completed.
Send card No.
0 to 9
Next digit
Power
Decimal ABA form code, decimal
Warranty
The product is warranted against defects in material and workmanship while used in normal service for
a period of 1 year from the date of sale to the original customer. The GEM policy is one of continual
development and improvement; therefore GEM reserves the right to change specifications without
notice.