Gateway 9210 - Manual (Page 86)

81 www.gateway.com
System board specifications
Processor mPGA478 package
800/533/400 MHz system bus
Supports either 1 Intel Pentium 4 or 1 Intel Celeron CPU
Chipset Intel 827210
■ Intel 827210 Memory Controller Hub (MCH) (Northbridge)
■ Intel 6300ESB I/O controller (Southbridge)
■ Intel 82802AC 8 Megabit Firmware Hub (FWH)
Memory ■ Four 184-pin DDR SDRAM Dual Inline Memory Module (DIMM) slots
support as much as 4 GB unbuffered ECC system memory
■ Support for single-sided or double-sided DIMMs (DDR266/333/400)
■ To run DDR400 memory at full speed use an Intel Pentium 4
processor with 800 MHz system bus frequency.
■ To run DDR333 memory at full speed use an Intel Pentium 4
processor with 533 MHz system bus frequency. Note: DDR333
memory will run at 320 MHz frequency when you use an Intel
Pentium 4 processor with system bus frequency of 800 MHz.
■ To run DDR266 memory use with an Intel Pentium 4 processor with
400 MHz or 533 MHz system bus frequency only.
PCI
devices/slots Three PCI-X 64-bit PCI slots
One 32-bit PCI slot
VGA On-board ATI Rage XL
■ 8 MB SDRAM
■ 1600 × 1200 (2D) max
■ 1024 × 768 (3D) max
LAN ■ One Intel 82547EI Platform LAN Connect (PLC) device for
10/100/1000 Mbps Ethernet LAN connectivity
■ One Intel 82551QM device for 10/100 Mbps Ethernet LAN
connectivity
SCSI ■ Optional add-in Ultra 320 SCSI controller card through the PCI slot.
ACPI ACPI compliance
Supports:
■ S0
■ S1
■ S4
■ S5