Gardena Art. 875 - Manual (Page 5)

13
GB
3.3. Assembly Instructions for Pressure Sprayer Art. No. 875 / 879 / 880
1. Push the short union nut G over the spray hose 5 .
2. Push on the spray hose 5 so that it covers at least the
beginning of the thread H .
3. Screw the short union nut G onto the container cap I
and tighten by hand (do not use pliers).
1. Remove the spray tube holder J from above (direction of
the arrow).
2. Guide the shoulder strap K through the elongated hole
of the spray tube holder J and attach it into the holder L
of the container.
3. Press the spray tube holder back on until you hear it click
into place.
4. Attach the shoulder strap on the other side of the holder L .
4. Operation
4.1. Operating Instructions for Pressure Sprayer Art. No. 867 / 869
1. Mix the fluid well.
2. Unscrew the container cap B .
3. Pour the fluid into the container up to the maximum mark
(3 litres or 5 litres).
Please observe the safety and proportioning instructions provid-
ed by the manufacturer of the product you are going to spray.
4. Screw the container cap B back on and tighten by hand
(do not use pliers).
Risk of injury !
A
V Never connect your Pressure Sprayer to an air
compressor.
5. Pull the pump lever N repeatedly (approx. 30 to 40 times)
until the operating pressure has been reached.
Any excess pressure escapes through the safety valve
O .
Attaching the spray hose
to the container cap :
Attaching the shoulder strap :
Filling the container :
K
L
J
L
G H
5
I
O
N
B