Grizzly Air Palm Nailer H6141 - Manual (Page 10)

h6141 air palm nailer -10 -
cleaning & lubrication
cleaning
use a good solvent to clean the nose
piece and depth guide of the nailer. always
be sure that the nailer is dry before using
it again.
Do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
nailer; this may result in leaks and dam-
age to the nailer and the air couplings.
lubricating
special oil has been included with your
new grizzly nailer to help maintain its
useful life. place two to six drops of oil in
the nailer air inlet (as shown in
figure 4)
before every use, or after 2 hours of con-
tinuous use.
Wipe off any excess oil near the nailer
exhaust to avoid dust build-up. We recom-
mend lubricating your nailer with grizzly
Model g2820 pneumatic tool oil.
another option to manual oiling would be
to install a lubricator in your air compressor
line. if your air compressor line already has
a lubricator, then regular manual lubrica-
tion of your nailer will not be necessary.
Just make sure there is always oil in the
lubricator.
figure 4. lubricating nailer via air inlet.
never use gasoline or other flamma-
ble liquids to clean this tool. vapors
in the tool may ignite, causing the
tool to explode. ignoring this warning
may lead to serious personal injury or
even death!