Greenway Home Products Muskoka MEF2822CWG User Manual

Page 3

Advertising

GET REAdy To sTART

Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use
a box cutter or exacto-knife as you may cut into the mantel pieces inside the box and
damage the finish. Check for the hardware bag which is red and located inside the
packaging, taped to the top box. Be sure you DO NOT discard any pieces.

step 1

Locate the base and place it on the floor. Do not put it up against the wall at this point
in the assembly, as you need to get in behind the mantel to insert several wingnuts, lock
washers and firebox screws.

step 2

Locate the left side panel and the left front panel. Facing the front of the base, take the
left side panel, positioning it so the holes in the blocks on the bottom line up with the
holes on the base. Position the left front panel next to the left side panel, lining up the
holes in the blocks with the holes on the base. Attach the left front and side panel to
the base by inserting and tightening 1 wingnut and 1 lock washer to each piece. Attach
the left side and front panels together by inserting and tightening 3 wingnuts and 3 lock
washers.

step 3

Repeat Step 2, but with the right side panel and the right front panel.

step 4

Locate the lower facing panel and the firebox shelf. Attach the lower facing panel by
placing the granite side to the front then line up the holes on each side and insert 1
wingnut and 1 lock washer into each. Place the firebox shelf in behind, right up against
the lower facing panel.

step 5

Locate the granite upper facing panel that will be attached to the left and right legs and
will sit above the firebox. Position this panel with the granite side facing the front of
the mantel. Line up the holes on each side and insert and tighten 1 wingnut and 1 lock
washer on each side.

step 6

Get your assistant and locate the top of your mantel. This top is very heavy. It will take
2 people to lift and position it in place. Ensure the top goes over the positioning guide
located on the header. The top must go over this guide to be positioned correctly. Line up
the holes on the top of the mantel, insert and tighten 5 wing nuts and lock washers.