Global Machinery Company LS211 - Manual (Page 12)

12
3. Loosen the mitre locks (15).
4. Rotate the table (12) until the pointer is positioned at 0º.
5. Tighten the mitre locks (15).
6. Loosen the bevel lock (7) and set the saw arm (1) at 0º
bevel (the blade at 90º to the mitre table). Tighten the
bevel lock (7).
7. Place a set square against
the table (12) and the flat
part of the blade (fig. J).
Note. Make sure that the
square contacts the flat
part of the saw blade, not
the teeth.
8. Rotate the blade by
hand and check the
blade-to-table alignment
at several points.
9. The edge of the set square
and the saw blade should
be parallel.
10. If the saw blade angles
away from the set
square, adjust as follows.
11. Use an 8mm wrench
or adjustable wrench
to loosen the lock nut
securing the 0° bevel
adjustment screw (10).
Also, loosen the bevel
lock (7) (fig. K).
12. Adjust the 0° bevel
adjustment screw (10)
using a 4mm hex key
to bring the saw blade
into alignment with the
square (fig. L).
13. Loosen the Phillips head
screw holding the pointer
of the bevel scale (8)
and adjust the position
of the pointer so that it
accurately indicates zero
on the scale. Retighten
the screw (fig. M).
14. Retighten the bevel lock
(7) and the lock nut
securing the 0° bevel adjustment screw (10).
Note. The above procedure can also be used to check the
angle of the saw blade to the table at 45º bevel angle.
The 45° bevel adjustment screw (9) is on the opposite
side of the saw arm.
Setting the fence square with the table
1. Make sure that the electrical plug is removed from the
power point.
2. Push the saw arm (1) down
to its lowest position and
engage the release knob (2)
to hold the saw arm in the
transport position.
3. Loosen the mitre locks (15).
4. Rotate the table (12) until the
pointer is positioned at 0º.
5. Tighten the mitre locks (15).
6. Using a 5mm hex key,
loosen the two screws
securing the fence (11) to
the base (fig. N).
7. Place a square against the
fence (11) and alongside
the blade (fig. O).
8. Adjust the fence (11) until
it is square with the blade.
9. Tighten the screws securing the fence (11).
J
M
K
L
N
O
90 0
90
0