Cleaning the print head, Checking ink levels, Cleaning the print head checking ink levels – Epson WorkForce 630 User Manual

Page 27

Advertising
background image

Cleaning the Print Head

27

Cleaning the Print Head

If print quality has declined and the nozzle check indicates clogged nozzles, you
can clean the print head. Print head cleaning uses ink, so clean it only if necessary.

Note:
You cannot clean the print head if an ink cartridge is expended, and may not be able to
clean it when a cartridge is low. You must replace the cartridge first (see page 29).

1. Load a few sheets of plain paper.

2. Press

F

Setup

.

3. Press u or d to select

Maintenance

, then press

OK

.

4. Press u or d to select

Head Cleaning

, press

OK

, then press

OK

again.

5. Choose the colors you want to clean.

Tip:
Use the nozzle check pattern to determine which colors
need cleaning. You can save ink by cleaning only
selected colors.

Cleaning lasts around 2 1/2 minutes. When it’s
finished, you see a message on the LCD screen.

Caution:
Never turn off the product during head cleaning or you may damage it.

6. Press

2

to run a nozzle check and confirm that the print head is clean.

Note:
If you don’t see any improvement after cleaning the print head four times, leave the
product on and wait at least six hours to let any dried ink soften. Then try cleaning the
print head again. If quality does not improve, one of the ink cartridges may need to be
replaced. If that doesn’t help, contact Epson as described on page 54.

If you do not use your product often, it is a good idea to print a few pages at least once
a month to maintain good print quality.

Checking Ink Levels

You can check the ink levels anytime right on the LCD screen. To check the ink
levels with your Windows or Macintosh software, see the instructions in your
online User’s Guide.

Advertising
This manual is related to the following products: