Epson WorkForce 630 - Manual (Page 56)

56 Notices
■ Keep the product away from potential sources of electromagnetic interference, such as
loudspeakers or the base units of cordless phones.
■ Allow space behind the printer for the cables, and space above the printer so that you
can fully raise the document cover.
■ Leave enough room around the product for sufficient ventilation. Make sure the
product is at least 4 inches (10 cm) away from the wall.
■ Do not block or cover openings in the product case or insert objects through the slots.
■ Do not use aerosol products that contain flammable gases inside or around the
product. Doing so may cause fire.
■ Do not press too hard on the document table when placing the originals.
■ Do not open the scanner section while the product is copying, printing, scanning, or
faxing.
■ Be careful not to trap your fingers when closing the scanner cover or scanner.
■ Do not touch the flat white cable inside the product.
■ Do not spill liquid on the product. Do not use the product near water. Do not use
with wet hands.
■ Unplug the product and refer servicing to qualified service personnel under the
following conditions: if the power cord or plug is damaged; if liquid has entered the
product; if the product has been dropped or the case damaged; if the product does not
operate normally or exhibits a distinct change in performance.
■ Adjust only those controls that are covered by the operating instructions. Except as
specifically explained in your documentation, do not attempt to service the product
yourself.
■ Never disassemble, modify, or attempt to repair the product by yourself, except as
specifically explained in the documentation. Do not adjust controls that are not
covered by the operating instructions.
■ When storing or transporting the product, do not tilt it, stand it on its side, or turn it
upside down; otherwise ink may leak from the cartridges.
■ Always keep this guide handy.
LCD Screen Safety
■ Use only a dry, soft cloth to clean the LCD screen. Do not use liquid or chemical
cleansers.
■ If the LCD screen is damaged, contact Epson. If the liquid crystal solution gets on
your hands, wash them thoroughly with soap and water. If the liquid crystal solution
gets into your eyes, flush them immediately with water. If discomfort or vision
problems remain after a thorough flushing, see a doctor immediately.