Grizzly H8126 - Manual (Page 12)

-10-
H8126 Wide Wheel Ginder
Inventory
After all the parts have been removed from the
box, you should have the following items:
Box Contents: (Figures 3 & 4) Qty
A. Wide Wheel Grinder (Not Shown) .............. 1
B. Left Spark Guard ....................................... 1
Right Spark Guard (Not Shown) ................ 1
C. Eye Shields ................................................ 2
D. Nut Plates ................................................... 2
E. Bracket ....................................................... 2
F. Left Tool Rest ............................................ 1
Right Tool Rest (Not Shown) ..................... 1
G. Hardware and Tools (Not Shown): Qty
— Hex Bolts 1 ⁄
4
"-20 x 3 ⁄
8
" (Eye Shield) ......... 2
— Phillip Head Screws 8-32 x 3 ⁄
8
"
(Eye Shield) ............................................ 4
— Flat Washers 4mm (Eye Shield) ............. 4
— Hex Nuts #8-32 (Eye Shield) .................. 4
— Flat Washers
1 ⁄
4
" (Eye shield) ................. 2
— Flat Washers 5 ⁄
16
" (Tool Rest) ................. 4
—Hex Bolts 5 ⁄
16
"-18 x 3 ⁄
8
" (Tool Rest) ......... 4
Figure 3. Left eye shield assembly.
If any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Figure 4. Left tool rest.
B
C
D
E
F
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed. Check mount-
ing locations before assuming that any
items from the inventory list are missing.
Inventory