Greenway Home Products Muskoka MM289CW - Manual (Page 3)

GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is red and located inside the packaging taped to the top box. Be sure you DO
NOT discard any pieces.
For the easiest assembly, use a power Phillips-head screwdriver. DO NOT over tighten the screws.
Step 1
Locate the hearth and place it on the floor. Do not put it up against
the wall at this point in the assembly as you need to get in behind
the mantel to insert several screws.
Step 2
Locate the left side panel and the left front panel. Facing the
front of the hearth, take the left side panel, positioning it so the
holes in the blocks on the bottom line up with the screw holes
in the hearth. Locate the left front panel and position it next to
the left side panel, lining up the holes in the blocks with the
screw holes in the hearth.
Step 3
Repeat Step 2, but with the right side panel and the right
front panel.
Step 4
Locate the lower central panel and the firebox support.
Attach the lower panel by placing the wide white side to the front
and inserting the 4 screws. Be careful as you tighten the screws to
ensure that you DO NOT come through the front of the panel. Attach
the firebox support behind the first panel in the same manner, lining
up the 2 holes (one on each side) with the holes in the legs. Insert
and tighten the 2 screws. Be careful as you tighten the screws to
ensure that you DO NOT come through the side of the mantel.
Place the firebox shelf onto the firebox supports. Attach the shelf to
the supports by inserting and tightening the 4 screws.