Gefen EXT-COMPAUD-CAT5-142 - Manual (Page 12)

9
ADJUSTING THE VIDEO QUALITY
The 1:2 Component Audio Over CAT5 receiving unit can adjust both the
brightness and focus of the reproduced video signal. Differences in cable skew
and distance are factors that can affect these settings. To adjust these settings
and tune the video signal please use the steps below.
Brightness
If the image appears too dim or too bright, adjust the brightness trim pot on the front
of the Component/Audio Receiver.
Insert a small fl athead device into the brightness trim pot hole and turn the trim pot
in either a clockwise or counterclockwise direction. Turn the trim pot in very small
increments until the desired brightness is reached.
Focus
If the image is out of focus, or the colors are smeared, adjust the focus trim pot on
the front of the Component/Audio Receiver.
Insert a small fl athead device into the focus trim pot hole and turn the trim pot in
either a clockwise or counterclockwise direction. Turn the trim pot in very small
increments until the image clears and there is not blurriness or smearing.