Gateway E1400 User Manual
Page 69
62
System Components
c
Lift the heat sink at an angle and unhook the clip from the other
tab. Lift the heat sink off the processor.
4
Remove the processor:
a
Open the locking lever on the processor socket by moving the lever
slightly out to the side and then lifting it up 90 degrees.
b
Lift the old processor straight up and out of the socket.
5
Install the new processor:
a
Hold the new processor over the empty processor socket and verify
that pin 1 on both the processor and the socket are aligned. Pin
1 is near the cut out corner.
b
Gently place the new processor into the socket.
c
Secure the processor by lowering the locking lever until the lever
latches into place. The processor will slip into place without
pressure when aligned correctly.
Locking
lever
Processor
Pin 1
05960.book Page 62 Monday, February 21, 2000 2:47 PM