Grizzly G0527 - Manual (Page 25)

G0527 18" Wide Belt Sander -23-
OFF
ON
Disconnect power to the
machine when perform-
ing maintenance, assem-
bly or adjustments.
Failure to do this may
result in serious person-
al injury.
Wear safety glasses dur-
ing the entire mainte-
nance process. Failure
to comply may result in
serious personal injury.
The following items should be checked each
time the sander is used:
• Loose mounting bolts.
• Damaged sanding belt.
• Worn or damaged wires.
• Air line water collection cup is filled with
water.
• Any other condition that could hamper the
safe operation of this machine.
Weekly:
• Grease the eight fittings located on the feed
belt roller axles and the sanding belt roller
axles. They are identified with yellow stick-
ers.
Monthly:
• Apply a generous amount of grease to the
table elevation screws. Be sure to cover the
adjustment screws with the dust covers
when finished.
• Remove the lower side panel to access the
table lifting mechanism. Apply a generous
amount of grease to the chain and gears
associated with the table lifting mechanism.
Be careful to not get grease on any of the V-
belts. This could cause them to slip off their
pulleys.
• Apply a generous amount of multi-purposed
grease to the table drive chain and sprocket
assembly.
Loose hair and clothing
could get caught in
machinery causing seri-
ous personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Your safety is important! Please follow the
warnings below during this entire section:
Schedule General
SECTION 7: MAINTENANCE