Grizzly Random Orbital H6192 - Manual

Product Information
• 10,000 RPM
• Requires 90 PSI
• Requires 5 CFM
• Requires 5" hook and loop sanding disc with
5-hole pattern
• 1 /
4
" NPT air inlet
• Weighs 2.4 lbs.
• 1 1 /
4
" Dust port
• Directional exhaust port
Inventory
A. Orbital Sander ..............................................1
B. Wrench .........................................................1
MODEL H6192
RANDOM ORBITAL SANDER
INSTRUCTION SHEET
EYE INJURY HAZARD!
Always wear safety glasses
when using this tool to
prevent serious personal
injury.
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service.
DUST HAZARD!
Always wear respirator when
using this tool. Figure 1 . Model H6192 inventory.
Assembly
To assemble the Model H6192:
1. Install a 1 ⁄
4
" NPT male quick-connect fitting
(not included) into the air inlet.
2. Attach a 5" hook and loop sanding disc to the
sanding pad as shown in Figure 2.
A
B
Figure 2. Attaching sanding disc.
COPYRIGHT © AUGUST, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#BL8505 PRINTED IN TAIWAN
DO NOT EXCEED 120 PSI!
Personal injury could
occur.