GE Monogram ZEK73WP - Manual (Page 31)

How to Set Oven for Cleaning
Quick Reminder:
1. Prepare the oven for cleaning.
2. Close the oven door completely.
3. Press the CLEAN pad.
4. Press the INCREASE or DECREASE pad
until desired Clean Time appears.
If the oven is too hot and you start to set a clean cycle,
the word “OFF” will appear in the display. Allow
additional time for cooling before you try to
set the cycle.
1. Follow directions to prepare the oven for cleaning.
Press the CLEAN pad.
CLEAN
3. Press the INCREASE or
DECREASE pad until desired
Clean Time is displayed.
Clean Time is normally 3 hours. You can
change the Clean Time to anywhere
between 2 and 4 hours, depending on how
dirty your oven is.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for the clean
cycle is set. The word “ON” will appear on the
display. When the oven heats up the word “LOCK”
will be displayed and the door will lock automatically.
It will not be possible to open the oven door until the
temperature drops below the lock temperature and the
LOCK light goes off.
4. When the LOCK light is off, open the door.
NOTE: can find out when the
STOP
clean cycle be finished by pressing
TIME the STOP TIME button.
I I
The word “door” will be displayed, the word “LOCK”
will flash and oven control will signal if you set the
clean cycle and forget to close the oven door.
To Stop a Clean Cycle
1. Press the pad.
CLEAR
2. Wait until the oven has cooled below locking
OFF
temperature. You will not be able to open the
door right away unless the oven temperature is
at a safe level.
(continued next
31