Global Machinery Company FQC54V - Manual (Page 11)

11
To obtain the best life for the tool
The screwdriver should be placed on charge whenever the
chuck/bit retainer (1) no longer turns. DO NOT continue
to use the screwdriver when the charge is exhausted. The
screwdriver does not have automatic spindle lock and using
the screwdriver with no charge may damage the tool.
During operation avoid overloading the screwdriver.
Doing so will allow you to maximise the charge run time.
Avoid allowing loose items like screws or nails etc. to be
stored with tool as these or similar items can short battery
packs and cause a fire or explosion.
Always unplug the charger when not in use and store in
a dry secure place.
Using the screwdriver
Direction of Rotation/Forward and Reverse
The screwdriver has a
rocker-type switch for operating
the screwdriver in forward
or reverse. To operate the
screwdriver in the forward
direction, depress the top half
(forward arrow) of the switch (2).
To operate the screwdriver in
reverse, depress the bottom half
(reverse arrow) of the switch (2).
To stop the screwdriver, release
the switch and allow the motor
to come to a complete stop.
Inserting and removing bits
1. Select an appropriate bit and
Insert it into the hexagonal hole
in the chuck/bit retainer (1).
The screwdriver is now ready
for use.
2. To remove the screwdriver bit
you simply remove the existing
bit by pulling the bit out of the
chuck/bit retainer (1).
Maintenance
• Store the tools, instruction manual and where necessary
the accessories in the original packaging. In this way you
will always have all the information and parts on hand.
• If the cordset of the charger is damaged or worn, have it
repaired or replaced by an authorised service centre in
order to avoid a hazard.
• Service to the tool should only be performed by qualified
repair persons using identical replacement parts. This will
ensure the safety of the power tool.