Graco Nautilus 1753283 - Manual (Page 33)

33
4. Tighten vehicle seat belt
Push down hard with your knee or free hand
in the middle of the child restraint
™ .
Then pull and tighten the vehicle belt.
For more information on how to tighten the
belt for your seat belt system, see Section 7.0
Choosing an Appropriate Vehicle Seat Location,
p.18, or your vehicle owner’s manual.
5. If a vehicle top tether anchor is available,
secure the tether to hold seat in place.
See Section 18.0 Using the Tether, page 55.
When not using the tether, hook it on the tether
storage bar on the rear of the seat, see page 56.
6. Safety Check for Secure Installation
Perform this test every time you drive with your child.
Twist and pull child restraint forward and to
both sides to make sure the vehicle belt does not
lengthen or loosen and the child restraint does not
easily move. The child restraint should not move
side to side or forward more than 1 inch (2.5 cm). š.If
child restraint is loose or not secure, repeat procedure
OR find another location for the child restraint, see
Section 7.0 Choosing an Appropriate Vehicle Seat
Location, p. 18.
™
š