Global Machinery Company LSM210A - Manual (Page 13)

13
T
6. Loosen the bevel lock (16) and set the saw arm (5) at
0º bevel (the blade at 90º to the mitre table). Tighten the
bevel lock (16) (Fig. S).
7. Place a set square against the table (21) and the flat part
of the blade.
Note. Make sure that the square contacts the flat part of the
saw blade, not the teeth.
8. Rotate the blade by hand
and check the blade-to-table
alignment at several points.
9. The edge of the set square
and the saw blade should be
parallel.
10. If the saw blade angles away
from the set square, adjust
as follows.
11. Use a 13mm wrench or
adjustable wrench to loosen
the lock nut securing the 0°
bevel adjustment screw
(34) (Fig. T). Also, loosen the
bevel lock (16).
12. Adjust the 0° bevel
adjustment screw (34) with
the 6mm hex key to bring
the saw blade into alignment
with the square.
13. Loosen the Phillips head
screw holding the pointer
of the bevel scale (17) and
adjust the position of the
pointer so that it accurately
indicates zero on the scale.
Retighten the screw (Fig. U).
14. Retighten the bevel lock
(16) and the lock nut
securing the 0° bevel
adjustment screw (34).
Note. The above procedure can
also be used to check the angle
of the saw blade to the table at
45º bevel angle. The 45° bevel
adjustment screw (33) is on the
opposite side of the saw arm (Fig. V).
Setting the fence square with the table
1. Make sure that the electrical plug is removed from the
power point.
2. Push the saw arm (5) down to its lowest position and
engage the release knob (6) to hold the saw arm in the
transport position.
3. Loosen the mitre lock (25).
4. Rotate the table (21) until the pointer is positioned at 0º.
5. Tighten the mitre lock (25).
6. Using the 6mm hex key
provided, loosen the four
screws securing the fence (18)
to the base (Fig. W).
7. Place a square against the
fence (18) and alongside
the blade.
8. Adjust the fence (18) until it is
square with the blade.
9. Tighten the screws securing
the fence (18).
10. Loosen the Phillips head
screw holding the pointer
of the mitre scale (22) and
adjust it so that it accurately
indicates the zero position on
the mitre scale (Fig. X).
11. Retighten the screw securing the mitre scale pointer.
S
V
U
W
X