Genesis I.C.E. Genesis 5.2 - Manual (Page 5)

ver 1.0 5 55 5
~ДлздмнЙ=СбЗЙдбну™
Set-up Guide
Positioning
A good starting position for the G5.2 is about 20% of the way into
the room as measured from the front wall (the wall you look at as
you are seated listening to the speakers). Start with the speakers six
feet apart, and not toed-in. You will want to sit 10 to 12 feet away
from the speakers (if you have the space). We will experiment with
moving the speakers around, and toeing them in later.
Power Connections
There are two connections you will
need to make to the G5.2. First, the
power cord for the built-in amplifier
will need to be plugged into a power
socket. A 10-foot power cord is
included with your speakers for this
purpose. We do not recommend
using an extension cord for the G5.2
due to the high power demands of
the 500W amplifier. However, if you
MUST use an extension cord, use an
extremely heavy duty one.
Before you plug the power cord in,
please make sure that the voltage
selector is set to the proper voltage.
Taiwan, Japan and North America
will require the 115v setting. Most
European countries and other Asian
countries will require 230v. We
recommend that you plug the G5.2 into an unswitched outlet, or a
switched outlet that will always be left ON.
There is an on/off switch for the power amplifier. This switch should
always be left on. The built-in amplifier has an auto-sensing circuit
that will automatically put the amplifier on stand-by when there is no
music being played for around 10 minutes. It will immediately switch
the amplifier on if there is music sensed.
Source Input Connections
Connect the output of your power amplifier to the High Level Input
binding posts using a high-quality loudspeaker cable. Make sure that