GE PROFILE PGP989SN - Manual (Page 2)

Dimensions and Installation Information
For answers to your Monogram, ® GE Profile ™ or
GE ® appliance questions, visit our website at
ge.com or call GE Answer Center ® service,
800.626.2000. Dimension and installation information are shown in inches.
Listed by
Underwriters
Laboratories
PGP989SN
GE Profile ™ 30" Downdraft Gas Cooktop
Specification Revised 4/09
230285
Installing the Ductwork: Use galvanized
or aluminum duct in 6” round or 3-1/4” x
10” size, or combination of both.
PVC duct
or locally approved piping should be used
if installing under a poured concrete slab.
Local building code must be followed in
specifying type and schedule of all duct used.
Note: Ductwork must be vented to outside.
Do not vent into a wall, ceiling, crawlspace,
attic or any concealed space. Always use
an appropriate roof or wall cap with damper.
Laundry-type wall caps should never
be used. For maximum efficiency use the
shortest and straightest duct run possible,
with as few fittings as possible.
For satisfactory performance the duct run
should not exceed 100 feet equivalent length.
Refer to the table of equivalent lengths
(shown in installation instructions) for
various duct configurations.
Rear Wall Venting Downward Venting
Venting Options
Through Cabinet Toe Space Inside Wall to Roof Direct to Outside Between Floor Joist
9-1/8
10-1/8
18-3/4
6-1/8