Grizzly G4186Z - Manual (Page 21)

G4186Z 18" Bandsaw -19-
Table Adjustment
The bandsaw table will tilt left 10° and right 45°
from horizontal. There is a positive stop adjusting
stud so the table can be reset perpendicular to
the blade after tilting it left or right.
To tilt the table:
1. Loosen the two knobs below the trunnions.
See Figure 18 for knob location.
Figure 18. Trunnion lock knob.
2. Position the table to the desired angle.
Refer to the angle gauge on the table sup-
port bracket.
3. Tighten the knobs.
If you are setting the table tilt to the left, first tilt
the table to the right, loosen the check nut on the
positive stop adjusting stud, remove the stud, and
then tilt the table to the left.
Figure 19 shows the
table in its maximum left tilt position.
Figure 17. Lower guide adjustments.
Guide
Block
Guide Block
Setscrew
Support
Bearing
Bearing
Setscrew
Guide Block
Thumbscrews
The bandsaw blade is dangerously sharp.
Use extreme caution when working near the
saw blade. Failure to exercise care could
result in severe injury.