Graco ComfortSport - Manual (Page 33)

1/2 inch (1 cm)
(fig. a)
VEHICLE SEAT BELTS
(continued)
Avoid serious injury or death:
• Failure to use locking clip where
required will result in child
restraint not being securely held
in place.
• Remove locking clip from seat
belts when not being used with
child restraint.
• DO NOT use locking clip as a
vehicle seat belt shortener.
WARNING
❃
Locking Clip
Test installation to see if child restraint is secure.
If not secure, additional belt tightening may be
required:
• Unbuckle vehicle seat belt.
• Hold belts together and remove locking
clip.
• Shorten length of lap belt portion slightly
by pulling belt through latch plate.
• Re-attach locking clip.
• Buckle vehicle seat belt.
Press child restraint further down into vehicle
seat cushion to help buckle vehicle seat belt.
Test installation to see if child restraint is secure.
If not secure, repeat above step until secure.
You MUST use locking clip provided with
child restraint with a vehicle seat belt that
slides freely through the latch plate or the lap
belt cannot be tightly secured.
Install child restraint and tighten vehicle
seat belt.
Hold seat belts together at latch plate (fig. a)
then unbuckle.
Slide locking clip on seat belts approximately
1/2 inch (1 cm) away from latch plate.
Re-buckle seat belt.
1
2
3
4
5
31