Grizzly G0444 - Manual (Page 45)

G0444/G0444Z 10" Table Saw -43-
3. Tighten down one trunnion bolt a small
amount and then move on to each of the oth-
ers, tightening each down the same amount.
4. Continue to rotate through the bolts, tighten-
ing them a little each time until they are all
secure.
5. Flip the saw rightside up and repeat steps 2-
6 on page 41 .
6. Once the miter slot is adjusted parallel to the
blade, recheck all measurements and be
sure the table mounting bolts are secure.
7. Re-attach the blade guard and the fence.
8. Verify that the blade guard is correctly
aligned with the blade.
Figure 57. 45° blade parallelism measurement.
#1
#3 #2
Figure 56. 45° blade parallelism measurement.
#1
45˚ Bevel
45˚ Bevel
#3
#4
#4
#2
If the trunnion assembly is loosened in the
future, make note of the shim locations and
re-assemble accordingly.
NOTICE
!
!
Front
Front
A
B