GE EGR2001 User Manual
Page 49
49
ge.com
Problem
Possible Causes
What To Do
Display goes blank
A fuse in your home may be
• Replace the fuse or reset the circuit breaker.
(on some models)
blown or the circuit
breaker tripped.
The clock is turned off so that it •
See the Using the clock and timer section.
does not show in the display.
Display flashes
Power failure.
• Reset the clock.
(on some models)
Unable to get the
Oven control pads were
• The Bake and Broil Hi/Lo pads must be touched at
display to show “SF”
not touched properly.
the same time and held for 3 seconds.
(on some models)
Power outage,
Power outage or surge.
• Reset the clock. If the oven was in use, you must reset
clock flashes
it by touching the Clear/Off pad, setting the clock and
(on some models)
resetting any cooking function.
“Burning” or “oily” odor
This is normal in a new oven
• To speed the process, set a self-clean cycle for a
emitting from the vent
and will disappear in time.
minimum of 3 hours. See the Using the self-cleaning
oven section.
Strong odor
An odor from the insulation
• This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
A cooling fan may automatically
• This is normal. The cooling fan will turn off and on.
turn on and off to cool
internal parts.
Drawer does not slide
The drawer is out of alignment.
• Fully extend the drawer and push it all the way in.
smoothly or drags
See the Care and cleaning of the range section.
Drawer is over-loaded or load
• Reduce weight. Redistribute drawer contents.
is unbalanced.
Operating
Instructions
Care and Cleaning
Installation
Instructions
Tr
oubleshooting T
ips
Safety Instructions
Consumer Support