Global Machinery Company 040521 ED8 PR - Manual (Page 10)

10
Blade guard
The blade guard (13) provides
protection from both sides of
the blade.
With the power disconnected,
adjust the guard so that it’s
parallel with and just slightly
higher than the thickness of
the tile you are going to be
cutting.
Turning on and off
1. To start the saw insert the
switch disabling insert and
move the switch (3) up to
the ‘ON’ position.
2. Move the switch (3) down
to the ‘OFF’ position to
turn the saw off.
3. Remove the switch disabling insert to prevent
unauthorised use and store it in a secure location out
of reach of children.
Turning on the REDEYE ®
laser line generator
The REDEYE ® laser line
generator emits an intense
narrow beam of pure red light
to guide you as you cut. It
improves operator cutting
vision, enables faster set-up, increases accuracy and
improves safety. To turn the laser line on and off press
the laser light on/off switch (24).
Installing a blade
DANGER.
• Never try to use a blade larger
than the stated capacity of
the saw. It will come into
contact with the blade guard.
• Never use a blade that is
too thick to allow the outer
blade washer to engage with
the flats on the spindle. It
will prevent the blade screw
from properly securing the
blade on the spindle.
1. Adjustments are only to be
made with the power off,
the tool disconnected from
the mains supply and when
the blade has fully stopped.
2. Loosen and remove the blade
cover locking knobs (10).
3. Remove the blade cover (9).
4. Take the 2 face spanners
and use 1 to hold the blade
securing nut and the other
to hold the flat part of the
spindle. Turn the spanner